Product User Guide

I. User Guide

Battery & Power Management
- Use only genuine Skyfire batteries. Mixing different battery types/voltages is strictly prohibited.
- Power off immediately when brightness fluctuates significantly to prevent over-discharge.
- Charging Tip: Starting with low brightness modes helps extend LED and battery lifespan.
Operation Instructions
1. Battery Installation
- Rotate the tail cap counterclockwise to open.
- Insert batteries with positive (+) terminals facing the head.
- Tighten the tail cap clockwise (observe polarity markings).
2. Lighting Modes
-High Mode: Search/rescue, long-range illumination
- Medium Mode: General mid-range lighting
- Low Mode: Close-range precision tasks
- Strobe Mode: Emergency signaling/defense
- SOS Mode: Distress signal
3. Charging Methods
- Direct Charging: Connect USB charger to the flashlight's charging port (compatible with most standard chargers).
- Dock Charging: Place battery in charging dock per polarity markings, then connect to power.
- Charging begins when indicator lights up.

II. Safety Warning

-Never shine directly into eyes (may cause temporary blindness).
- Children must use under adult supervision.
- Heat generation during high-power operation is normal. Alternate between high/low modes for extended use.

III. Maintenance

1. Routine Care: Apply petroleum jelly to O-rings/threads 2-3 times yearly.
2. Cleaning: Wipe lens with cotton swabs dipped in specialized cleaner.
3. Long-term Storage: Remove batteries and store in dry conditions.
4. Environmental Protection: Avoid sunlight exposure and contact with corrosive chemicals.

IV. Troubleshootin

1. Check Batteries: Ensure adequate charge and correct installation.
2. Check Connections: Verify all components are securely fastened.
3. Contact online support if issues persist.

V. Lithium Battery Specifications

1. Usage Guidelines
- Initial charge requires 6+ hours.
- Use only chargers withtriple protection (overcharge/reverse polarity/short circuit).
- For storage: Maintain full charge and perform monthly charge-discharge cycles.
2. Safety Protocols
- Prohibited in high-temperature environments.
- Replace batteries only with OEM equivalents.
- Chargers must carry CCC certification .